Rommelsbacher EKS 2000 - Descaling Procedure (Part 2); Continuing Descaling Process

39
Step 13:
Choose the function
“espresso/hot water”.
Step 14:
Switch the appliance on again.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
Step 15:
Continue the descaling process by
turning the rotary knob to the right.
Dispense decalcifier for15 seconds.
Step 16:
Stop the supply.
Turn the rotary knob to the left.
Step 17:
Switch the appliance off.
Step 18:
Remove the vessel.
Step 19:
Remove the portafilter.
Attention, the portafilter drips
slightly.
Step 20:
Remove the water tank.
Step 21:
Empty the water tank and clean it
thoroughly.
Step 22:
Fill the water tank with fresh tap
water.
Observe the “MAX” marking!
Step 23:
Insert the water tank.
Make sure the water tank is inserted
as far as it will go on the gasket.
Step 24:
Position the portafilter without filter
insert at the marking of the brew
head and lock it by turning it to the
right as far as it will go.
Step 25:
Place a vessel below the outlet of
the portafilter.
Step 26:
Choose the function
“espresso/hot water”.
Step 27:
Switch the appliance on.
The appliance heats up and the pilot
lamp blinks. When the lamp glows
permanently, the appliance is ready
for use.
CONTINUEDON
NEXT PAGE