5
Roper Pumps’ Close Coupled Drives
The hydraulic or gearmotor units mount directly to the pump.
o Alignment between pump and driveline is maintained by the assembly.
Because the assembly absorbs reaction forces of the driveline, the mounting base does not need to be as robust.
The level of rigidity and strength is determined by the piping stresses from the system
Guarding PTO Drive Shafts
PTO drive systems can be dangerous and when used, additional safety precautions, including guarding, is
required and must be provided by the drive system installer. Roper Pump Company has no responsibility for
recommending or providing proper guarding or other safety measures in any particular application.
NOTICE: The installation of proper guards for the power take-off and its associated equipment is the
responsibility of the drive system designer and the installer who know the particular product application
and the user’s exposure to danger.
The ultimate responsibility for the safe application and
installation is the users.
WARNING: Failure to stop the pump before adjusting the shaft packing can cause
serious injury or death.
To Next Page
Loading...
