USER MANUAL -DMG DASH™
4
SAFETY & PRECAUTIONS
General precautions
This product is designed for professional lighting technicians. It is not intended for
household use.
Risk of electric shock and fire
Do not open the product. There are no user-serviceable parts inside. Contact Rosco
for after sales and repair services.
Overheating
Do not operate the product if the ambient temperature exceeds 104ºF/40ºC, or
77ºF/25ºC in Boost Mode.
Intensive use can cause the surface of the fixture to become hot. Allow the product to
cool down completely before handling or storage.
• Should the DMG DASH overheat, the fixture will power off. It can be
powered on again once the unit has sufficiently cooled down.
• Operating the DMG DASH from the battery generates more heat
then when the fixture is connected to a power source via the charging
cable. If the fixture needs to perform in a demanding environment where
overheating may be possible, operating the DMG DASH via the charger is
advised to reduce the heat and prevent triggering the thermal protection
sensors.
Please Note: the DMG DASH light fixture, Flat Diffuser, Dome and DOT Round
items as much as possible. It is recommended that these products be stored in their
respective cases or bags during storage.
CERTIFICATIONS
EN 55015:2013+A1:2015
EN 61547:2009
EN IEC 61000-3-2:2019
EN 61000-3-3:2013+A1:2019
EN 62368-1:2014+A11:2017
EN 62479:2010
EN 62368-1:2014+A11: 2017
Luminaires - Part 1 EN60598-1
requirements for miscellaneous
electronic circuits used with luminaires
61347-2-11
IP54
Safety requirements for portable sealed
from them, for use in portable
IEC62133
Transport of dangerous goods
UN38.3
Transport of dangerous goods
1.2 meter drop test
Transport of dangerous goods
To Next Page
Loading...
Need help?
General