PaneLINK
Live Assist can be set to either mirror actions on the
switcher control panel, or only show actions on the
currently selected ME and Keyer on the current tab. For
example, with PaneLINK turned on, pressing KEY 1
SEL, WIPE, and then SELF KEY causes Live Assist
to show the Keyers tab, the Trans tab, and then the
Keyers tab again. With PaneLINK turned off, Live
Assist does not switch between tabs.
The PaneLINK button is located at the bottom right
corner of the window.
Custom Controls
The Custom Control node provides a graphics interface
for recording, editing, and running custom controls.
MediaManager
The MediaManager node allows you to connect to the
MediaManager web interface from within DashBoard.
Tip: You can either launch the MediaManager directly using
the switcher IP address, or you can access it using the
MediaManager node in DashBoard. If you are logging into
MediaManager from DashBoard, you must have Internet
Explorer
®
10, or higher, installed.
Carbonite Operation Manual (v10.1) — DashBoard • 21
To Next Page
Loading...
