Ross carbonite - To Set the Key On-Air Attribute; To Set the Key Type Attribute; To Set the Key Mask Attribute; To Set the Media-Store Attribute

To Set the Key On-Air Attribute
1.
Press RECALL > NEXT.
2.
Use the Attrib knob to select KActiv.
3.
Use the Key knob to select the keyer you want
to set the attribute for.
4.
Use the Value knob to select whether sources
selected on the selected key bus are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — sources are not recalled on the key
bus
•
Recall — sources are recalled on the key
bus (default)
To Set the Key Type Attribute
1.
Press RECALL > NEXT.
2.
Use the Attrib knob to select KType.
3.
Use the Key knob to select the keyer you want
to set the attribute for.
4.
Use the Value knob to select whether the key
type is recalled for the selected key.
•
Memory — settings come from the memory
being recalled
•
NoRcl — key type is not recalled
•
Recall — key type is recalled (default)
To Set the Key Mask Attribute
1.
Press RECALL > NEXT.
2.
Use the Attrib knob to select KMask.
3.
Use the Key knob to select the keyer you want
to set the attribute for.
4.
Use the Value knob to select whether mask
settings for the selected key are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — key mask settings are not recalled
•
Recall — key mask settings are recalled
(default)
To Set the Media-Store Attribute
1.
Press RECALL > NEXT.
2.
Use the Attrib knob to select Media.
3.
Use the Media knob to select the Media-Store
channel you want to set the attribute for.
4.
Use the Value knob to select whether
Media-Store image and settings for the selected
channel are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — Media-Store image and settings
are not recalled (default)
•
Recall — Media-Store image and settings
are recalled
To Set the Aux Bus Attribute
1.
Press RECALL > NEXT.
2.
Use the Attrib knob to select Aux.
3.
Use the Aux knob to select the aux bus you want
to set the attribute for.
4.
Use the Value knob to select how the sources
selected on the aux bus are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — sources are not recalled on the aux
bus (default)
•
Recall — sources are recalled on the aux
bus
To Set the Camera Shot Attribute
1.
Press RECALL > NEXT.
2.
Use the Attrib knob to select CamRcl.
3.
Use the Value knob to select whether camera
shots are recalled.
•
Memory — settings come from the memory
being recalled
•
NoRcl — camera shots are not recalled
•
Recall — camera shots are recalled (default)
To Set the Roll GPO Attribute
1.
Press RECALL > NEXT.
2.
Use the Attrib knob to select RllGPO.
3.
Use the Value knob to select whether GPI
outputs attached to sources are triggered when
recalled.
•
Memory — settings come from the memory
being recalled
46 • Memory Functions — Carbonite Operation Manual (v10.1)