Ross carbonite - Switcher Sets; To Store a Set; To Load a Set

Switcher Sets
The switcher stores conguration and operation data in
a number of registers that contain the individual entries
for items such as memories or personality settings. These
registers can be stored as a single archive le, or as a
register set that contains all the individual register of that
type; all memories for example. These les are stored
into Sets on USB drive. Different Sets can be created for
different shows or applications, allowing you to quickly
locate and recall the switcher congurations.
The switcher stores information in the following registers:
• Memory — contains all the memories for all MEs
• Custom Control — contains all the custom control
banks and macros
• Personality — contains all the user interface
settings, such as transition rates, that are stored
under the PERS menu
• Installation — contains all the external device
setup, and software settings for the switcher
To Store a Set
Switcher Sets can only be stored to a USB drive. The
USB drive must be present before you try to store the
Set. A total of 10 Sets of switcher setup information can
be stored onto the same USB drive.
1.
Insert a USB drive into the USB Port on the
switcher. You must wait 5 seconds for the
switcher to recognise the USB drive.
2.
Press MENU > SAVE.
3.
Use the Save knob to select the set (0-9) you
want to store the switcher registers to.
4.
Press the knob to select the registers you want
to store to the selected set. If an (*) is shown on
the menu, that register already exist in the set
and will be overwritten.
•
ALL — store all registers to the set
•
Mems — store only the memory registers
to the set
•
Cust — store only the custom control
registers to the set
•
Pers — store only the personality registers
to the set
•
Inst — store only the installation registers
to the set
5.
Press Confrm.
To Load a Set
Switcher Sets can only be loaded from a USB drive. The
USB drive must be present before you try to load the
settings.
1.
Insert your USB drive into the USB Port on the
switcher. You must wait 5 seconds for the
switcher to recognise the USB drive.
2.
Press MENU > LOAD.
3.
Use the Load knob to select the set (0-9) you
want to load the switcher registers from.
4.
Press the selected set. Only registers with an (*)
shown on the menu exist in the set.
•
ALL — recall all registers from the set
•
Mems — recall only the memory registers
from the set
•
Cust — recall only the custom control
registers from the set
•
Pers — recall only the personality registers
from the set
•
Inst — recall only the installation registers
from the set
5.
Press Confrm.
48 • Switcher Sets — Carbonite Operation Manual (v10.1)