Ross ULTRIX-MODX-IO - Hardware Overview; Supported Routers; Hardware Features

ULTRIX-MODX-IO User Guide (v1.0) Hardware Overview • 13
Hardware Overview
This chapter outlines the hardware features of the ULTRIX-MODX-IO.
Supported Routers
You can install the ULTRIX-MODX-IO into the following Ultrix routers:
• ULTRIX-FR1-NS
• ULTRIX-FR2-NS
• ULTRIX-FR5
• ULTRIX-FR12
Hardware Features
This section provides an overview of the ports, connections, and other hardware features of the
ULTRIX-MODX-IO.
Figure 1 ULTRIX-MODX-IO
1. USB 3.0 Port
This is an USB 3.0 Type A port and provides the ability for various USB-serial converters to be
attached for serial communications with the Ultrix router.
2. PSU Connection
Each ULTRIX-MODX-IO includes a power connector that requires a 15VDC connection to an
external power supply. The blade supplies up to 15W per module.
 Refer to the Ross Ultrix Configuration Tool on our website, or contact Ross Technical Support for
help determining if this power connection is needed for your system.
3. AUX A-D Ports
The AUX ports are labeled as A-D starting with the leftmost port. AUX A and AUX B support:
› HDMI
› Unidirectional coax
› Bidirectional coax
› Fiber
› MADI
› SFP+ (10G)
1
 AUX C and AUX D are reserved for future use.
1) USB 3.0 Port 3) AUX A-D Ports 5) Module Slots
2) PSU Connection 4) Retaining Bolt 6) Blade Retaining Screws
1. SFP28 (25G) is not supported.
ULTRIX-MODX-IO
!
BA C D
1234
ULTRIX-MOD-SFP
1234
ULTRIX-MOD-SFP
1234
ULTRIX-MOD-SFP
1234
ULTRIX-MOD-SFP
1 2 3 4
5
6 6