AC-015 Page 26 March 2008
To exit programming, press the “#” key for two
seconds. Three beeps are generated and the
system will return to NORMAL mode. A short
press on the “#” key will also return the system to
NORMAL mode, and a long beep will be heard.
This aborts the programming, but in some cases,
such as Program Function #7, data may have
already been programmed.
Wrong entries during programming may also
abort programming, along with long beep
generation.
All programming operations are done either
from the on-board keyboard or from the
external reader. Programming PROX. employee
codes requires using proximity reader and
proximity cards.
To Next Page
Loading...
