Rosslare AC-015 User Manual

AC-015 Page 27 March 2008
Entering Programming Mode
To begin programming the controller’s settings, the
AC-015 must first place into Programming Mode. You
may only enter Programming mode from Normal
mode, the controller does not permit entry to
Programming Mode if the controller is in Bypass and
Secure Mode.
1) Press the “#” key for 2 seconds
• The DOOR LED will
turn red
Mode Door
RED
2) Enter the Programming Code. The factory
default Programming Code is 1234.
If the Programming Code is valid the controller
will be in Programming Mode.
• The DOOR LED will
turn green
Mode Door
GREEN
If the Programming Code is NOT valid the
controller will emit a loud beep and will NOT
enter Programming Mode.

Rosslare AC-015 Specifications

General

Brand	Rosslare
Model	AC-015
Category	IP Access Controllers
Language	English