AC-015 Page 37 March 2008
Enrolling Proximity Cards / Tags and
Keyboard Codes into the System
NOTE: Each proximity card is unique and can only be
assigned to one slot at a time. If an
unassigned proximity card is enrolled at an
occupied slot, the AC-015 will generate a long
beep and wait for another slot number to be
entered. The card at the current slot location
must be erased first, before a new code is
programmed on that slot number. The same
rules apply for PIN based employee codes.
1) Press the “#” key for 2 seconds
• You will hear a short beep
• The MODE LED will
turn off
• The DOOR LED will
turn red
Mode Door
RED
2) Enter the 4-digit
Programming Code for
confirmation. (Default
code is 1234.)
?
?
?
?
• The DOOR LED will
turn green
• The MODE LED will be
off
Mode Door
GREEN
3) Press 7
• The MODE LED will
turn green
• The DOOR LED will
turn orange
Mode Door
GREEN ORANGE
4) Enter the 3-digit slot code
you wish to assign to the
employee (for example,
003 represents slot “3”).
???