AC-015 Page 43 March 2008
delete all your initial
settings and employees
from the system!)
• You will hear 3 beeps
• The system will return to Normal mode
IMPORTANT: You must be very careful before using this
command. Doing so will erase all of the
employee codes from the memory and all
of the special codes will return to their
default values. All preprogrammed cards,
PIN codes and special codes will have to
be preprogrammed from the beginning.
¾ For Facility Code Programming:
4) Press 1.
• The DOOR LED will
continue flashing red
• The MODE LED will
flash green
Mode Door
REDGREEN
5) Enter the 3-digit Facility
Code (must be between
0-255).
???
• The MODE LED will
turn green
• The DOOR LED will
continue flashing red
• If the wrong code is
entered the system
will exit programming.
Mode Door
REDGREEN
To Next Page
Loading...
