AC-020 Page 11 03/02
Introduction
The AC-020 is an advanced two door controller,
which allows you to add or delete employees
from the system, change system mode status
and change system authorization codes.
The AC-020 provides a higher level of security as
the programmer is normally placed in a secure
location while the reader sensors are remotely
located outside the controlled premises. Should a
remote sensor be attacked, entry cannot be
gained as the remote sensor only provides data
to the programmer, not authorization to release
the controlled door.
The AC-020 accepts up to 500 employees for
each door via the use of proximity cards
(provided separately) or PIN. Each employee is
issued a unique proximity card or PIN code.
Employees designated 01 to 10 are Master users
and can operate the system in both the Normal
and Secure modes of operation. Employees 11 to
500, when entered from the external reader
sensor may only operate the Controller in the
Normal and Bypass modes of operation.
It is very important to keep an accurate record of
the slot number and its assignment to each
employee. This is to enable you to add additional
employees at a later time or to delete a Prox. or
PIN code if one is lost or stolen. A record form is
To Next Page
Loading...
Need help?
General
