Input and Output Requirements
AC-225 Hardware Installation and User Guide Page 26
Single door controller: Door 1 – Reader 1 IN/OUT
Door 1 – Reader 2 IN/OUT
Double door controller: Door 1 – Reader 1 IN/OUT
Door 2 – Reader 2 IN/OUT
Use the VeriTrax AS-225 software to set the readers for IN or OUT
use and to set the data transmission format for each reader.
The reader’s tamper output connects to the access control
panel's Reader-Tamper input. If the reader is interfered with, an
alarm can be generated.
The panel's Reader G.LED output activates the reader’s green
LED input when operating in "Card and PIN" secure mode.
While this mode is in force, users must enter a PIN on the
keypad immediately after entering the card.
The controller activates the LED control for 2 seconds when an
access granted event occurs.
To Next Page
Loading...
