AC-225 Hardware Settings
1 2 3 4 5 6 7 8
Figure 15: DIP Switch with Baud Rate Setting
The following lists switch 1 and 2 status and baud rate:
Switch 1 Switch 2 Baud Rate
Off Off 9600
Off On 19200
On Off 115200
On On 57600
Note:
The access control panel baud rate must be identical to
the host computer's serial port baud rate.
5.3 Access Control Panel Type
The Access control panel type is defined using the third DIP
switch. Set the panel to operate as either a single or double
door controller.
The default access control panel setting is for a single door
controller.
AC-225 Hardware Installation and User Guide Page 29
1 2 3 4 5 6
7 8
Figure 16: DIP Switch with Single Door Setting
• Off - defines single door controller
• On - defines a double door controller
To Next Page
Loading...
