Rosslare AC-F43 - Switching Operational Modes

Operation
26 AC-F/G4x Series Installation and Programming Manual
4.3
Switching Operational Modes
The three modes of operation defined above can be changed
through a few steps.
4.3.1 From Normal to Secure Mode
The default factory setting for the normal/secure code is 3838.
To change from Normal to Secure mode:
1.
Enter the 4-digit Normal/Secure code.
The left LED flashes red.
2.
Press # to confirm the mode change.
The left LED stops flashing.
The auxiliary input of the controller can also be used to switch
the mode of operation from Secure to Normal and vice versa. If
the auxiliary input is selected it de-activates the Norma/Secure
mode code (see Section 5.9).
4.3.2 From Secure to Normal Mode
The default factory setting for the normal/secure code is 3838.
To change from Secure to Normal mode:
1.
Enter the 4-digit Normal/Secure code.
The left LED flashes green.
Green
Red
Red