Issue 3 Original version March 2012
- 3 -
Contents
Page
1) Intended Use 3
2) General safety 4
3) Machine Specification 5
4) Operating instructions 6
5) Cutsmart™ Feature 7
6) Mounting of cutters 8
7) Remedies for hole making problems 8
8) Wiring Diagram 9
9) Speed Selection 10
10) Exploded diagram of machine 11
11) Exploded diagram of motor 13
12) Pipe adaptor Kit 15
13) Chuck conversion 16
14) Maintenance checks 16
15) Trouble shooting 18
16) Cutter selection and speeds and feeds information 19
17) Warranty 20
1) INTENDED USE
The magnetic drill is intended for use to drill a hole in a ferrous material. The magnet is used to hold the drill in
place whilst the drill is functioning elevating the stress placed on the user and increase the low precision that
would be incurred when using a hand held drill. It is designed for use in Fabrication, Construction, Railways,
Petrochemical and any other application when drilling ferrous metal. Any deviation from its intended use will
not be the subject of responsibility from Rotabroach.
2) GENERAL SAFETY RULES
WARNING! When using electric tools basic safety precautions should always be followed to reduce the risk of fire, electric shock and
personal injury, including the following.
Read all these instructions before attempting to operate this product
Remove the power supply before carrying out any adjustment, serving or maintenance.
1. Keep work area clear cluttered areas and benches invite injuries.
2. Consider work area environment
Do not expose tools to rain.
Do not use tools in damp or wet locations.
To Next Page
Loading...
