2
Column Greasing:
Two post lifts finished with powder coat must have grease applied to the columns. Lifts are greased from the factory,
however, it is advised to check and ensure that the columns are still greased when installing the lift. If your lift has a model
number that matches the following table, grease the columns with either Lighting grease, Tuf Oil, Sil Glide, or an equivalent
grease.
Apply the grease to the columns by wiping on a thin layer and polishing with a rag. Only apply grease on surfaces of the
columns where the slider blocks make contact. Be careful not to apply too much grease, only a thin layer is needed, wipe
off excess.
Lift Series Model Number
SPOA7
1000 SPOA7x10xx
1100 SPOA7x11xx
1200 SPOA7x12xx
SPO10
1000 SPO10x10xx
1100 SPO10x11xx
1200 SPO10x12xx
SPOA10
1000 SPOA10x10xx
1100 SPOA10x11xx
1200 SPOA10x12xx
To Next Page
Loading...
