56
To avoid personal injury and/or property damage, permit only trained personnel to operate lift. After
reviewing these instructions, get familiar with lift controls by running the lift through a few cycles before
loading vehicle on lift.
Always lift the vehicle using all four adapters. NEVER raise just one end, one corner, or one side of
vehicle.
Authorized personnel
only in lift area.
©
CAUTION
Read operating
and safety manuals
before using lift.
©
SAFETY
INSTRUCTIONS
CAUTION
Lift to be used
by trained operator
only.
©
?
?
?
CAUTION
Use height extenders
when necessary
to ensure
good contact.
©
CAUTION
Use vehicle
manufacturer’s
lift points.
©
CAUTION
Auxiliary adapters
may reduce
load capacity.
©
WARNING
Remain clear of lift
when raising or
lowering vehicle.
©
Observe and heed Safety, CAUTION and Warning labels on
the lift.
1. Before Loading: Lift must be fully lowered and service
bay clear of all personnel before the vehicle is brought
on lift. Swing arms out to full drive-thru position.
2. Spot vehicle over lift with left front wheel in proper
spotting position, Fig. 1.
3. Loading: Swing arms under vehicle and position
adapters at vehicle manufacturer’s recommended lift
points, Fig. 2. Use intermediate, high step, or optional
adapters for under body clearance when required.
Note: Allow (2) seconds between motor starts. Failure to
comply may cause motor burnout.
DO NOT rest adapter against edge of arm.
4. To Raise Lift:
A. For all lifts. Push Raise switch on power unit, Fig. 3.
B. Stop before making contact with vehicle. Check
arm restraint pins for engagement. If required,
slightly move arm to allow restraint gear and pawl
to mesh. DO NOT hammer pin down as this will
damage the restraint gear teeth.
C. Raise vehicle until tires clear the floor.
D. Stop and check adapters for secure contact at
vehicle manufacturer’s recommended lift points.
E. Continue to raise to desired height only if vehicle is
secure on lift.
F. Do Not go under vehicle if all four adapters are
not in secure contact at vehicle manufacturer’s
recommended lift points.
G. Repeat complete spotting, loading and raising
procedures if required.
H. Lower lift onto locking latches.
WARNING
WARNING
Clear area if vehicle
is in danger of falling.
©
OPERATING INSTRUCTIONS
DO NOT REST ADAPTER
AGAINST EDGE OF ARM
*Maximum operation pressure is:
2103 psi (14500 kPa) for SPOA7
2755 psi (18995 kPa) for SPO9, SPOA9
2755 psi (18995 kPa) for SPO10, SPOA10, SPOA10NB
To Next Page
Loading...
