d07068.fm
SI-912 i-029 / SI-915 i-012
SI-916 i-007
SERVICE INSTRUCTION
08 February 2024 74-20-00
Initial Issue Page 5 of 15
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
3) Accomplishment/Instructions
- ROTAX
®
reserves the right to make any amendments to existing documents, which might
become necessary due to this standardization, at the time of next revision or issue.
NOTE: Before maintenance, review the entire documentation to make sure you have a com-
plete understanding of the procedure and requirements.
Accomplish-
ment
All measures must be implemented and confirmed by at least one of the following persons or
organizations:
- ROTAX
®
- Airworthiness representatives
- ROTAX
®
- Authorized Distributors or their independent Service Centers
- Persons approved by the respective Aviation Authorities
- Persons with approved qualifications for the corresponding engine types. Only authorized per-
sons (iRMT, Level Heavy Maintenance) are entitled to carry out this work
- Persons with type-specific training
-
NOTE: Indicates supplementary information which may be needed to fully complete or under-
stand an instruction.
General Further material on general inspection, maintenance and repair can also be found in relevant Advi-
sory Circular AC 43.13 from FAA.
Advisory
Circular
The Advisory Circular (AC) contains maintenance methods, techniques and practices.
3.1) Illustrated Parts Catalog - related information
3.2) Installation - related information
All work has to be performed in accordance with the relevant ROTAX
®
Instructions for
Continued Airworthiness (ICA) of the respective engine type.
See current Illustrated Parts Catalog (IPC) for the respective engine type, Chapter 24-
20-00 and Chapter 74-20-00.
See current Installation Manual (IM) for the respective engine type, Chapter 24-00-00.
To Next Page
Loading...
