Need help?Do you have a question about the Rotax 912 i series and is the answer not in the manual?
General| Number of Cylinders | 4 |
|---|---|
| Max Power | 100 hp (73.5 kW) |
| Max Power Output RPM | 5800 rpm |
| Ignition System | Dual electronic ignition |
| Oil System | Dry sump, forced lubrication with separate oil tank |
| Reduction Gear Ratio | 2.43:1 |
| TBO | 2000 hours |
| Engine Type | 4-stroke, horizontally opposed |
| Displacement | 1352 cm³ |
| Bore x Stroke | 84 mm x 61 mm |
| Max Torque | 128 Nm |
| Fuel Type | Avgas 100LL or unleaded automotive gasoline |
| Fuel System | Electronic fuel injection |
| Cooling System | Liquid/air-cooled |
Introduction to the maintenance manual, emphasizing careful reading and understanding.
Provides a list of abbreviations and their meanings used in the manual.
Explains safety symbols used in the manual and general safety precautions.
Provides critical safety information regarding engine usage and limitations.
Divides maintenance into Line and Heavy Maintenance categories.
States that airworthiness limitations are not applicable for the ROTAX® engine type 912 i Series.
Outlines requirements for ensuring continued airworthiness through inspections.
Details requirements for personnel performing maintenance tasks.
Lists specified and recommended consumable materials for maintenance.
Outlines acceptable practices for inspection, maintenance, and repair.
Defines Time Between Overhaul (TBO) and its maintenance implications.
Specifies general overhaul due dates and time limits for engine operation.
Lists components and systems requiring replacement every 5 years.
Lists periodic inspections required at specified intervals.
Details inspections recommended for specific malfunctions or conditions.
Details specific maintenance tasks and their intervals.
Details checks required after any propeller strike incident.
Guides on examining the engine after a failure to find possible causes.
Actions to take when oil pressure falls below the minimum value.
Procedures for inspecting the engine after a lightning strike.
Identifies key servicing points on the engine with an overview diagram.
Details checks and procedures for the engine's cooling system.
Step-by-step guide for checking and topping up engine oil.
Procedures for checking various engine components for leaks.
Steps for performing a differential pressure test on cylinders.
Detailed steps for conducting an engine test run.
Detailed steps for performing an engine oil change.
Emphasizes the importance and procedure for purging the oil system.
Procedures for replacing spark plugs, including inspection.
To Next Page
