BRP-Rotax
MAINTENANCE MANUAL LINE
LEAK TESTS
General note
ATTENTION
Avoid over-tightening the fastening elements. Use a suitable torque wrench for
all work.
Instruction To check the following steps are necessary:
Step
Procedure
1 Inspect all fuel lines, their connections and unions.
2
Inspect the fuel lines for sign of chafing.
CHECKING THE FUEL LINES
General note
See Chapter 05–10–00 section Time limit for parts.
Instruction
Step
Procedure
1
Inspect all hoses for porosity and other damage in particular at the hose
clamps and connections and replace as required.
2 Check fuel line (of steel).
CHECKING THE FUEL PRESSURE REGULATOR
General note
Step
Procedure
1
Check the fuel pressure regulator (1) for damages and inspect the general
condition.
2 Perform a leak test (Fuel pumps “ON”).
3
Inspect all connections (2) for secure attachment.
12–20–00
Page 30
September 01/2018
Effectivity: 912 i Series
Edition 2/Rev. 0
To Next Page
Loading...
