Rotax 912 i series Service Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Step
Procedure
6
Install new oil filter.
7
Pour in approx. 3 l (0.8 gal (US)) of fresh oil.
8 After carrying out the oil change, the engine should be slowly cranked by
hand in the direction of engine rotation (approx. 20 turns) to completely refill
the entire oil circuit.
OIL FILTER REPLACEMENT
General note
m WARNING
Risk of burns and scalds. Hot engine parts.
Always allow engine to cool down to ambient temperature before starting work.
ATTENTION
To ensure correct functioning of the oil circuit and the forced flow lubrication,
use ORIGINAL-ROTAX®- oil filter only. Only these filters will ensure correct pres-
sure in the by-pass valve.
At every oil change, unscrew the oil filter and cut open using special tool taking care not to
produce chips.
Special tools To carry out the procedure the following tools are necessary:
Effectivity: 912 i Series
Edition 2/Rev. 0
12–20–00
Page 35
September 01/2018

Rotax 912 i series Specifications

General

Number of Cylinders	4
Max Power	100 hp (73.5 kW)
Max Power Output RPM	5800 rpm
Ignition System	Dual electronic ignition
Oil System	Dry sump, forced lubrication with separate oil tank
Reduction Gear Ratio	2.43:1
TBO	2000 hours
Engine Type	4-stroke, horizontally opposed
Displacement	1352 cm³
Bore x Stroke	84 mm x 61 mm
Max Torque	128 Nm
Fuel Type	Avgas 100LL or unleaded automotive gasoline
Fuel System	Electronic fuel injection
Cooling System	Liquid/air-cooled