Rotax 912 i series Service Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
EXCEEDING THE MAX. PERMISSIBLE OIL TEMPERATURE
General note
ATTENTION
If the max. permissible oil temperature is exceeded, other limits are often ex-
ceeded, too, e.g. the cylinder head temperature. Please observe the relevant
instructions.
NOTE
Any exceeding of the max. admissible oil temperature must be entered by the pilot
into the engine log book, stating duration extant of excessive temperature and
pertinent detail.
Read out the ECU data memory and check the data for details of increased oil tempera-
ture. Perform the corresponding inspections/repairs depending on the functional defects
found.
Proceed as instructed
in table 4
Proceed as instructed
in table 3
Operating limit
(See Operators Manual 912 i Series)
160 °C
(320 °F)
0
15 min. Time
Figure 5.13: Overview and proceed
Effectivity: 912 i Series
Edition 2/Rev. 0
05–50–00
Page 23
September 01/2018

Rotax 912 i series Specifications

General

Number of Cylinders	4
Max Power	100 hp (73.5 kW)
Max Power Output RPM	5800 rpm
Ignition System	Dual electronic ignition
Oil System	Dry sump, forced lubrication with separate oil tank
Reduction Gear Ratio	2.43:1
TBO	2000 hours
Engine Type	4-stroke, horizontally opposed
Displacement	1352 cm³
Bore x Stroke	84 mm x 61 mm
Max Torque	128 Nm
Fuel Type	Avgas 100LL or unleaded automotive gasoline
Fuel System	Electronic fuel injection
Cooling System	Liquid/air-cooled