Rotax 912 i series Service Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
REPLACING THE DRY AIR FILTER
General note Only use dry type air filters which are specified by the aircraft manufacturer and from
ROTAX®.
Figure 7.12: Overview. TYPICAL
1 Air filter
ATTENTION
Each air filter must be secured by clamp attachment and a wire securing element.
See chapt. 05-00-00 section: Acceptable methods, techniques and practice.Filter
connection must be free of oil.
ATTENTION
Attach new air filter, free of grease, at connection faces, and wire-secure against
loss.
12–20–00
Page 22
September 01/2018
Effectivity: 912 i Series
Edition 2/Rev. 0

Rotax 912 i series Specifications

General

Number of Cylinders	4
Max Power	100 hp (73.5 kW)
Max Power Output RPM	5800 rpm
Ignition System	Dual electronic ignition
Oil System	Dry sump, forced lubrication with separate oil tank
Reduction Gear Ratio	2.43:1
TBO	2000 hours
Engine Type	4-stroke, horizontally opposed
Displacement	1352 cm³
Bore x Stroke	84 mm x 61 mm
Max Torque	128 Nm
Fuel Type	Avgas 100LL or unleaded automotive gasoline
Fuel System	Electronic fuel injection
Cooling System	Liquid/air-cooled