Rotax 912 i series Service Manual

BRP-Rotax
MAINTENANCE MANUAL LINE
Chapter: 12–10–00
REPLENISHING OPERATING FLUIDS
TOPICS IN THIS CHAPTER
Servicing points on the engine ................................................................................................................2
Fluid capacities .......................................................................................................................................3
Cooling system .......................................................................................................................................4
Coolant check/replenish.........................................................................................................................4
Lubrication system..................................................................................................................................7
Oil level check/Replenish .......................................................................................................................7
Introduction The engine should always be in a horizontal position before checking the fill levels.
ENVIRONMENTAL NOTE
All operating materials and cleaning products endanger the environment by
improper disposal.
Dispose of the operating materials in an environmentally sound way!
Effectivity: 912 i Series
Edition 2/Rev. 0
12–10–00
Page 1
September 01/2018

Rotax 912 i series Specifications

General

Number of Cylinders	4
Max Power	100 hp (73.5 kW)
Max Power Output RPM	5800 rpm
Ignition System	Dual electronic ignition
Oil System	Dry sump, forced lubrication with separate oil tank
Reduction Gear Ratio	2.43:1
TBO	2000 hours
Engine Type	4-stroke, horizontally opposed
Displacement	1352 cm³
Bore x Stroke	84 mm x 61 mm
Max Torque	128 Nm
Fuel Type	Avgas 100LL or unleaded automotive gasoline
Fuel System	Electronic fuel injection
Cooling System	Liquid/air-cooled