BRP-Rotax
MAINTENANCE MANUAL LINE
SAFETY NOTICE
Although reading such information does not eliminate any hazards, it promotes under-
standing, and applying of the information will promote correct use of the engine. Always
apply common workshop safety rules.
The information and descriptions of components and systems contained in this Manual
are correct at the time of publication. BRP-Rotax maintains a policy of continuous im-
provement of its products without imposing upon itself any obligation to retrofit products
previously manufactured.
Revisions BRP-Rotax reserves the right to remove, replace or discontinue any design, specification,
feature or other at any time, and without incurring obligation.
Measurement Specifications are given in the SI metric system with the imperial- and US customary
measurement system equivalents in parenthesis.
Symbols used This Manual uses the following symbols to emphasize particular information. This informa-
tion is important and must be observed.
m WARNING
Identifies an instruction which, if not followed, may cause serious injury or even
fatal injury.
m CAUTION
Identifies an instruction which, if not followed, may cause minor or moderate
injury.
ATTENTION
Identifies an instruction which, if not followed, may severely damage the engine
or could void any warranty.
NOTE
Indicates supplementary information which may be needed to fully complete or
understand an instruction.
ENVIRONMENTAL NOTE
Environmental notes give you tips on environmental protection.
TIP
This information gives you additional advice and tips.
A revision bar outside the page margin indicates a change to text or graphic.
00–00–00
Page 10
September 01/2018
Effectivity: 912 i Series
Edition 2/Rev. 0
To Next Page
Loading...
Need help?
General
