RLD | 3.0/4.01 6
1.4 Document Information
Revision History
2.1 / March 2011 New lexan
2.2 / June 2011 5.1 Corrected cold start procedure
2.3 / August 2011 Entire document Added RLD 7.2
2.4 / Dec 2011 6.1 ,6.2 Corrected wiring documents
2.5 / May 2012 6.1.1, 6.1.2 Separated sections
2.6 / June 2012 4.1.1 Changed supported light bulbs
2.7 / August 2012 6.2.1 Add new wiring diagram for board ver 2.1
2.8 / April 2013 4.1.1/5 Added warning/impedance spec
2.9 / August 2013 4.1.1.1 Added 4.01 functionality/profiles
3.0 / November 2013 4.1.1.1 Removed
3.1 / December 2013 8 Added new part numbers
3.2 / October 2014 6.1 New wiring diagrams
© 2011 Rotem Corp.
All rights reserved.
Document Number: 110036 Revision Number: 3.2
No part of this publication may be reproduced, stored in an automated data file or made public in any form
or by any means, whether electronic, mechanical, by photocopying, recording or in any other manner
without prior written permission of the publisher.
Rotem will not accept responsibility for damage resulting from the use of this manual. Rotem also reserves
the right to make changes and improvements to its products and/or the associated documentation without
prior notice.
2 PRECAUTIONS
CAUTION The COM connection for communications is not the shield wire. The COM, RX and TX
wires must connect to each other at all controllers.
WARNING! ONLY an authorized electrician may install the RLED. Power must be disconnected to
avoid electrical shock and damage. To avoid exposing the RLED to harmful gases or
high humidity, it is recommended to install it in the service room.
To Next Page
Loading...
Need help?
General
