Quick check
Lift the bike up so that the front or back wheel is off the ground and hit the wheel
hard in a downward motion a few times. The wheel should not be loose or fall off.
There should also be no gap between the wheel and the fork. This check does not
guarantee that the RWS lever has received sufficient pre-load force; the minimum
is 15 Nm. If you are uncertain if the RWS is mounted correctly please contact your
ROTWILD authorised retailer.
Riders and operators should have the functionality of the quick
release lever demonstrated by the ROTWILD authorised retailer.
Figure 11: RWS System front wheel
Figure 12: RWS System back wheel
35
To Next Page
