6.4 Adjusting the gear cables
If the gears will not engage cleanly the settings in the gear lever housing will
need correcting. Unscrew the gear cable housing on the gear lever housing by
hand in small steps and check the functionality every time after a correction has
been made.
In order to turn the gear cable housing it must be pulled out a little from its posi-
tion. Ensure that it is now sitting properly before testing the functionality.
If the gear cables cannot be adjusted in this way the assembly of the gear cables
should be checked by a ROTWILD authorised retailer.
Figure 18: Gear cable with housing
1 Gear cable housing
40
1
To Next Page
