7.9.1 Charging the drive battery
The drive battery should be charged in its position on the bike. Only use the char-
ger in a dry, dust-free environment. The temperature of storage must be within the
range of 10 °C to 30 °C. The charger will get very hot during charging. Ensure the
charger is used in a clean and highly inflammable environment.
The drive battery should be charged at it its position on the bike. It
is not possible to disassemble the drive battery so it can be char-
ged elsewhere.
The charger's power cable should be connected to a household earthed power so-
cket. The yellow LED will flash frequently to show that the charger is working.
Power connection information: 230 V, 50 Hz, 250 W
The charger's cable is inserted into the charging socket of the drive battery on the
down tube. The cable and the drive battery are magnetic and will guide the cable
into the correct position.
Charging will start automatically. The current battery status will be shown on the
display during charging. The battery status display will flash to show that it is
charging. The charger will flash infrequently to show that charging is ongoing.
The green indicator light will slowly flash once the battery is fully charged.
Should the charging process not proceed as described the charger and the drive
battery are to be taken out of use and taken to a ROTWILD authorised retailer.
71
To Next Page
