If you set your parking mode G-Sensor at 1, the dash cam
will be extremely sensitive. Even the lowest vibration, such
as hard tapping the LCD or Closing the Car's Door, will
activate the R2-4K Pro dash cam.
You would want this if you want your dash cam activated
with the slightest hit to the car.
However, there are downsides to this. Your dash cam will
activate even when you close the car's door while exiting
your vehicle. This will give you false parking mode got
activated alerts. However, the positive side of this is that
your car/dash cam is sensitive to minor bumps/hits to
your car.
If you set your parking mode G-sensor at just the right
setting, where it will NOT trigger the false alerts by closing
your car's door, you will NOT get false signals. Then when
you do get alerts, you know to check the last locked videos
to see what happened because you didn't anticipate the
false alerts.
However, the downside is that your dash cam is not extra
sensitive to more minor bumps/hits because you have set
your G-sensor to a higher level so that you may miss some
smaller bumps/hit events.
However, there is one more positive side; if you have used
time-lapse + collision detection, you should have your
parking mode time-lapse videos saved in normal folders.
So if you suspect someone might have hit your car or
something, then you can still always go look at the
time-lapse videos. We hoped this made sense and was
helpful.
1
2
56
USER MANUAL
To Next Page
Loading...
