The regulated DC power supply has been designed to provide the most often used features in the laboratory,
schools and production lines.
The output voltage is continuously adjustable between 0 and rated voltage in one range by means of a coarse and
fine potentiometer; the load current can be varied from 0 to rated current and adjusted by means of a coarse and fine
potentiometer. Both outputs can be accurately read on the voltmeter and ammeter.
Both stability and ripple are extremely good to meet the requirements of modern circuit design. The unit can be
used as either constant voltage or current source. The various modes of operation are described in greater detail in
Operation Instruction Section 4 of this manual.
For applications which use greater than the maximum voltage or Amps, then the unit can be connected up in
series or parallel. For applications in audio production lines, continuous or dynamic load.
To Next Page
Loading...
