Chapter 2. Introduction
3
Chapter 2. Introduction
FEATURES
The RP-6 provides superior quality and reliability as well as these specific features:
• Six multi-purpose output ports.
• Variable IR output power on all ports.
• Output ports support the optional RTI Modules (Power Sensing Modules, RS-232
Communication Modules, etc.). One Module can be plugged into each output port.
• Output ports are compatible with industry standard IR emitters and repeater
systems. All output ports incorporate both short-circuit and overload protection.
• One high output IR port for control up to 1000 feet away.
• One IR input port for passing IR codes through the output ports. Additionally, the
IR input can be used by RTI RF Receiver Modules and third-party universal remotes
or keypads to trigger the commands and macros stored in the RP-6.
• Three relay outputs for contact closure or low-voltage switching applications.
• Non-volatile Flash memory for program storage.
• One USB programming port.
• One expansion port.
NOTE
The RP-6 output ports are compatible with infrared (IR) commands that have carrier
frequencies between 15kHz and 460kHz, as well as those commands that do not use
a carrier. This covers virtually all of the remotes that exist to date.
In addition, when combined with a CM-232 communication module, the RP-6
output ports are compatible with RS-232 ports that operate at baud rates between
110 and 115.2K. This covers virtually all devices that exist to date.
To Next Page
Loading...
