Hardware Installation and Reference Guide Product Overview
24
All RJ45 ports are PoE+ capable and each port provides up to 30 W of power. The maximum power
depends on the configured power supply.
The PoE+ port is compliant with both the PoE (IEEE802.3af) and PoE+ (IEEE802.3at) standards.
The maximum number of PoE devices supported by the switch is determined by the available
PoE consumption of the switch and the actual PoE consumption of each device.
The PoE port is compliant with Alternative A.
Without PoE Load: < 65 W
With PoE Full Load: < 810 W
0ºC to 45ºC (32ºF to 113 ºF) at a height below 1800 m (1.12 miles) above the sea level
At a height ranging from 1800 m (1.12 miles) to 5000 m (3.11 miles) above the sea level, the maximum
operating temperature decreases by 1°C (1.8°F) every time the altitude increases by 220 m (721.78
ft.).
-40ºC to 70ºC (-40ºF to 158ºF)
10% to 90% RH (non-condensing)
0 to 5000 m (3.11 miles) above the sea level
5% to 95% RH (non-condensing)
Fan Speed Control
Fan Fault Alarming
Safety Regulation
Compliance
442 mm x 420 mm x 43.6 mm (17.40 in. x 16.54 in. x 1.72 in.)
Appearance
The front panel of the RG-S5310-24GT4XS-P-E switch provides 24 10/100/1000Base-T Ethernet ports (PoE+ capable), four 10GE SFP+
ports, one management port, one Console port and one USB port. The back panel has two power supply module slots.
Figure 1-25 RG-S5310-24GT4XS-P-E Switch Appearance