Ruijie Reyee RG-RAP2200 User Manual

Hardware Installation and Reference Guide System Debugging
13
4 System Debugging
4.1 Setting up a Debugging Environment
Use a power adapter or PoE to power the AP.
Setting up the Environment
 Verify that the AP is properly connected to the power source.
 Connect the AP to a wireless controller through a twisted pair cable.
 When the AP is connected to a PC for debugging, verify that the PC and PoE switch are properly grounded.
4.2 Powering up the AP
4.2.1.1 Checking before power-up
 Verify that the power supply is properly connected.
 Verify that the input voltage matches the specification of the AP.
4.2.1.2 Checking after power-up (recommended)
After powering up, it is recommended that you check the following to ensure normal operation of the AP.
 Check if any message is displayed on the Web-based configuration interface for the wireless controller.
 Check if the LED works normally.

Ruijie Reyee RG-RAP2200 Specifications

General

Brand	Ruijie
Model	Reyee RG-RAP2200
Category	Wireless Access Point
Language	English