Runxin F63C1 - Remote Handling Input; Pressure Relief Output; Maximum Interval Regeneration Days; All Parameters Can be Modified

MODEL 63504-F63C1/63604-F63C3/73504-F68C1/73604-F68C3
6
 Remote handling input
This connector can receive external signal, used together with PLC,
and computer etc. to control the valve. （ Application refer to
Figure3-11）
 Pressure relief output
The valve will cut off feeding water to drain line when it switches in
regeneration cycles(Same as signal output b-02). Thus in some water
treatment system, e.g. Deep Well, one booster pump was installed on
the inlet to increase the system water feeding pressure, this cut-off will
cause pressure on inlet rising too fast to damage the valve. Pressure
Relief Output can be used to avoid this problem. (Application refer to
Figure3-10)
 Maximum interval regeneration days
Under the situation of service reaching the setting days and the
volume not yet, it could enter into regeneration process forcibly when
current time is the same as regeneration time.
 All parameters can be modified
According to the water quality and usage, the parameters in the
process can be adjusted.