MODEL 63504-F63C1/63604-F63C3/73504-F68C1/73604-F68C3
11
① Install control valve
a. As the Figure 1-1 shows, select the riser pipe with 26.7mm OD, glue
the riser pipe to the bottom strainer and put it into the mineral tank, cut
off the exceeding tube out of tank top opening. Plug the riser tube in case
of mineral entering.
b. Fill the mineral to the tank, and the height is accordance with the
design code.
c. Remove the tap covering on the central tube and check if the riser
tube is on the central of tank.
d. Install the top distributor to the valve and insert the riser tube into
control valve and screw tight control valve.
Note:
● The length of riser tube should be neither higher 2mm nor lower 5mm
tank top opening height, and its top end should be rounded to avoid
damage of O-ring inside the valve.
● Avoid floccules substance together with resin to fill in the mineral tank.
● Avoid O-ring inside control valve falling out while rotating it on the tank.
② Install animated connector
As Figure1-2 shows, put the sealing ring into nut of animated
connector, and screw in water inlet.
③ Install flow meter
As Figure1-2 shows, put the sealing ring into nut of flow meter, screw
in water outlet; insert the sensor into flow meter.
④ Pipeline connection
a.As Figure1-3 shows, install a pressure gauge in water inlet.
b.Install valve A, B, C and D in the intermediate pipeline, inlet and outlet
valve D is a sampling valve. (Or adopt F70A/F70C bypass valve).
c.Install a check valve in water outlet.
d.Inlet pipeline should be in parallel with outlet pipeline. Support inlet and
outlet pipeline with fixed holder.
To Next Page
Loading...
Need help?
General
