MODEL 63504-F63C1/63604-F63C3/73504-F68C1/73604-F68C3
21
intelligent control mode, the control will automatically calculate the water
treatment capacity by setting resin volume, feed water hardness and
regeneration factor.
④ For A-01 or A-03 control mode (Delayed regeneration type), please
pay attention to whether the time is current or not. If the time is not right,
you can adjust as follow: After lifting the lock status, press , the and
light on. Then press , the and hour value flash. Press or
continuously, reset the hour value; Press again, and minute
value flash. Press or continuously, reset the minute value;
Press and hear a sound “Di”, then finish the adjustment. Press
exit and turn back the service status.
The regeneration parameters have been set when control valve left
factory. Generally, it does not need to reset. If you want enquiry and
modify the setting, you can refer to the professional application
specification.
To Next Page
Loading...
Need help?
General
