RUSH Wizard User Manual 23
2. Use the DOWN and UP buttons to change the microphone sensitivity
level from 0…100.
3. Press ENTER to set the level (or press MENU to exit without making a
change).
DMX state
The DMX state menu lets you set the fixture’s behavior when it is powered on
but is not receiving a DMX signal. You can set the fixture to:
• enter master/slave standalone operation
• blackout, or
• return to its last state.
Master/slave
To set the fixture to enter standalone operation and apply the master/slave
settings described at the beginning of this section (see page 21).
1. Select DMX STATE and press ENTER to confirm.
2. Use the DOWN and UP buttons to select MASTER/SLAVE and press
ENTER to confirm.
3. Use the DOWN and UP buttons to select ON or OFF.
4. Press ENTER to confirm (or press MENU to exit without making a
change).
Blackout
To set the fixture to black out:
1. Select DMX STATE and press ENTER to confirm.
2. Use the DOWN and UP buttons to select BLACKOUT.
3. Press ENTER to confirm (or press MENU to exit without making a
change).
Last state
To set the fixture to return to the last state it was in when was is not receiving
a DMX signal:
1. Select DMX STATE and press ENTER to confirm.
2. Use the DOWN and UP buttons to select LAST STATE.
To Next Page
Loading...