RUSH Wizard User Manual 25
2. Use the DOWN and UP buttons to select ON or OFF.
3. Press ENTER to confirm and power the lamp on or off (or press MENU to
exit).
Lamp Power On
To set the lamp to power on automatically when the fixture is powered on:
1. Select LAMP POWER ON and press ENTER to confirm.
2. Use the DOWN and UP buttons to select ON or OFF.
3. Press ENTER to confirm (or press MENU to exit without making a
change).
DMX lamp control
The lamp can be controlled remotely by DMX. The following options are
available:
• LAMP OFF VIA DMX allows the lamp to be powered off by sending a DMX
command.
• LAMP ON VIA DMX sets the lamp to power on automatically as soon as a
DMX signal is present.
• LAMP OFF IF DMX OFF sets the lamp to power off automatically as soon
as a DMX signal is not present
Ignition delay
An ignition delay of 0 to 255 seconds can be set, so that there is a delay
between power on and lamp on:
1. Select LAMP ON DELAY and press ENTER to confirm.
2. Use the DOWN and UP buttons to set a delay duration in seconds.
3. Press ENTER to confirm (or press MENU to exit without making a
change).
Fixture information
Fixture operating hours counter
To see how many hours the fixture has been in use since manufacture:
1. Select FIXTURE HOURS and press ENTER to display the number of
hours of use.
2. Press MENU to exit.
To Next Page
Loading...