Rush Wizard - Page 26

26 RUSH Wizard User Manual
Lamp operating hours counter
The fixture has a resettable lamp hours counter that displays the number of
hours the lamp has been used. Reset the counter to zero when you install a
new lamp, and check the counter frequently. Do not exceed the lamp lifetime,
or the lamp may explode causing damage that is not covered by the product
warranty.
To see how many hours the lamp has been in use:
1. Select LAMP ON HOURS and press ENTER to display the number of
hours the lamp has been in use.
2. Press MENU to exit the counter
To reset the lamp hours counter:
1. Select LAMP ON HOURS
and press ENTER. When the hours of use are
displayed, press ENTER again and then use the UP and DOWN buttons
to select RESET TIME.
2. Press ENTER to reset the counter to zero (or press MENU to exit without
making a change).
3. Press MENU to exit.
Firmware version
To see which fixture software is currently installed in the fixture:
1. Select FIRMWARE VERSION
and press ENTER to display the installed
firmware version.
2. Press MENU to exit.
Defaults
To return the fixture to its factory default settings:
1. Select DEFAULTS and press ENTER to confirm.
2. Use the DOWN and UP buttons to select YES (return to default settings)
or NO.
3. Press ENTER to confirm (or press MENU to exit without making a
change).