6.3 ) Sump
a) Remove any residual water from the sump by suction so that it does not flow into
the tub and the pressure switch tubes , then lay the appliance on the rear panel.
b) Remove lover cover. ( see 6 )
c) From inside tub ,remove the basket and lower spray arm .
d) Remove the microfilter group and metal filter .
c) detach all the hoses (sump – draining hose , circulation pump – sump, sump –
water softener)
f)Remove the four screws that secure the
tumb to the tub.
g) Remove the two screws which secure the
sp
ray arm support to the sump.
h) detach the drain pump and pull the sump
out ,taking care not to damage the tub seal.
52
To Next Page
Loading...
