Russell Hobbs RHDW1

Failure Codes : C1 Models
ERROR CODE
Wash End Start
/Pause
ERROR
DESCRIPTION
POSSİBLE PROBLEMS
Inadequate
water supply
• Make sure the water input tap is totally open and that there
is no water cut.
• Close the water input tap, separate the water input hose
from the tap and clean the filter at the connection end of
the hose.
• .Water inlet valve filter can be
• Water inlet valve can be out of order
• There can be a problem with the cable connection of water
inlet valve.
• Floater switch can be out of order or have a problem with
the cable connection.
• Pressure switch of the heater casing group can have a
mechanical or cable connection problem.
•
• Circulation pump can be out of order or have a problem
with the cable connection.
• Electronic card can be out of order.
Error of
continuous water
input
• Water inlet valve can be out of order or can not be
closed.
• Electronic card can be out of order.
The waste water
in the machine
cannot be
discharged.
• Water outlet hose is clogged.
• Water discharge hose can be out of order.
• There can be a problem with cable connection of the drain
pump.
• Pressure switch of the heater casing group can have a
mechanical or cable connection problem.
• Electronic card can be out of order.
Intended water
temperature
could not be
reached/ faulty
heater and/or
heater sensor
• NTC can be out of order.
• Faulty NTC cable connection can be faulty. NTCshort or
open circuit.
• Thermal protection can be out of order.
• Heater can be out of order or cable connection can be out
order.
Alarm is active
against water
overflow
• There can be a water leakage from the tub.
• Floater switch can be out of order or have a problem with
the cable connection.
• Electronic card can be out of order.
Electronic card
parameter faulty
• By the Immediate and continuous voltage decreases
software variants can not be kept in the memory of
electronic card.
Faulty
Flowmeter
• Cable connection of flowmeter can be faulty.
• Electronic card can be out of order.
Door is open
• Door lock mechanism can be out order.
• There can be o problem with the cable connection of door
lock.
• Electronic card can be out of order.
11