MEASURING THE COMPONENTS FROM THE
ELECTRONICAL CARD
a) b)
I
n order to reach the connections of the electronic card; dismantle the control panel
(Picture a) and probes of the tester should be applied on to the related connectors of
the electronical card; control the values according to the resistance value table.
(picture b)
Precaution : Always remove the plug from the power socket before touching internal
components.
Washing pump:
From the electronical card:
You can just measure the primary winding value from the electronical card.
Resistance value of the primary winding must be 95 Ω on the connectors CN2.3 –
CN2.9
A
bove sketch show the connectors of the washing pump on the electronical card.
Probes of the tester should be applied on to the related connectors.
ELECTRONİCAL CARD
CONNECTORS
ELECTRONİCAL CARD
CONNECTORS
PURPLE
YELLOW
CONNECTORS SHOULD BE MEASURED
54
To Next Page
Loading...
