Why doesn't my RYCO Crimp tool pump produce maximum pressure?
If your RYCO Crimp tool's pump works but doesn't achieve maximum pressure, start by checking the air pressure. You need 8.5 bar / 120 psi to reach the maximum operating pressure. Also, inspect the tool for any oil leaks.
How to fix a RYCO RY16-16 that doesn't close or closes slowly?
If your RYCO Crimp tool is closing slowly or not closing at all, there might be several reasons: * Check that all connections are fully tightened, as system components might be leaking. * Add oil if the fluid level in the reservoir is low. * Ensure the release valve is completely closed by hand. * Remove excess oil if there is too much fluid in the reservoir. If these steps don't resolve the issue, it may be due to air trapped in the system.
What to do if RYCO RY16-16 closes but doesn't hold pressure?
If your RYCO Crimp tool closes but doesn't hold pressure, ensure all connections are fully tightened, as system components might be leaking. If the issue persists, it could be due to fluid leaking past inlet or outlet checks, or worn or leaking seals. In these cases, you should contact RYCO Hydraulics for service.
Why pump of RYCO RY16-16 Crimp tool does not work and crimper can't close?
If the pump on your RYCO Crimp tool isn't working and the crimper can't close, check the air line pressure to ensure it's not low. Also, inspect the bore of the air piston for contamination and ensure it's properly lubricated, as a blocked air passage could be the cause.
What to do if pump works, but RYCO RY16-16 can't be closed?
If the pump of your RYCO Crimp tool works, but the crimper can't be closed, check the oil level and add oil if it's low. Also, there might be air in the oil line. Press down the switch valve (air) and push the foot pedal to the "Release" position simultaneously to resolve this.
Why does the RYCO RY16-16 Crimp tool pump handle have a spongy feel?
If the pump handle on your RYCO Crimp tool feels spongy, it might be caused by air trapped in the system.
Why does RYCO RY16-16 open too slowly?
If the pump on your RYCO Crimp tool works, but the unloaded crimper opens too slowly, check the hose assembly for kinks, as the oil return line might be blocked. Also, grease the crimper cones, as they might be dry.
Provides essential information for the safe use of the machine, including compliance standards.
Details the warranty coverage, conditions, and exclusions for the RY16 crimping machine.
Lists pre-delivery and pre-commencement inspection items required for the RY16 crimper.
Outlines critical safety instructions, warnings, and precautions for operating the crimping machine.
Step-by-step guide for operating the RY16 Mini Crimper, covering setup, die selection, and crimping.
Specifications, installation, and operating instructions for the RY16-HP hydraulic hand pump.
Technical data and operational details for the RY16-AP air/hydraulic foot pump.
Procedures for calibrating the RY16 Mini Crimper's vernier dial and troubleshooting the RY16-AP pump.
Operator-level maintenance tasks including cleaning, lubrication, oil changes, and spring replacement.
Lists part numbers and names for common spare parts for the RY16 crimper and pump.
General| Brand | RYCO |
|---|---|
| Model | RY16-16 |
| Category | Crimp tool |
| Language | English |
To Next Page
