3MINI CRIMPER SERIES OPERATION MANUAL
CHECKLIST
GENERAL
Pre-Delivery Checklist
Pre-Commencement Inspection
RY16
Crimper wrapped in plastic and packed in a
suitable box for Air & Sea freight
RY16 Crimper complete with
Quick Release Coupling
Tube of Grease
Technical User Manual
Grease Application Brush
Die Box
Die Sets
RY16
Included Dies
Optional Dies
Included Ordered
14mm 7mm
16mm 10mm
19mm 12mm
23mm
27mm
31mm
37mm
Before using the crimper for production, this checklist should be performed using procedures outlined herein.
Insert 9V Battery (not included) in battery holder.
Push red test button to check battery power and LED crimp light illuminates.
Check RYCO logo, safety labels and Crimp Chart decals are attached.
Check operation of Vernier Crimp dial.
Grease cone-shaped surfaces in the cylinder.
Connect Hand Pump or Air/Hyd. Foot Valve pressurise crimper to check for no oil leaks.
Check for no abnormal noise during operation across full range of motion.
Check all dies are supplied and appropriately numbered.
Check calibration as per calibration procedure.
RYCO recommend a risk assessment be performed by the end-user prior to installation and use.
To Next Page
Loading...
