n
n
n
n
n
See Figure 57.
n
n
n
n
See Figures 58 - 59.
1. Activate the chain brake.
2. Remove the two screws holding the engine cover.
3. Lift the front of the engine cover past chain brake lever.
4. Lift the back of the engine cover past the handle.
5. Before removing the air lter from the carburettor, blow
or brush as much loose dirt and sawdust from around
the carburettor and chamber as possible.
Note: Make sure to pull the choke rod out to keep the
carburettor from being contaminated.
6. Lift the air lter off the air lter base.
Choose one of the following cleaning options:
- To lightly clean, tap the filter against a smooth, flat
surface to dislodge most saw dust and dirt particles.
- After every 5 hours of operation, clean in warm soapy
water, rinse, and let dry completely. Replace with a
new filter after every 25 hours of use.
7. Reinstall the air lter.
Note: If you use an air hose for drying, blow through
both sides of filter.
See Figure 60.
See Figure 61.
n
n
Maintenance
n
n
n
To Next Page
Loading...
