126 Instruments and controls
was supplied by the manufacturer
of your garage door opener re‐
ceiver (motor-head unit).
2. At the same time, press and hold
both the hand-held transmitter
button and one of the three Uni‐
versal Home Remote buttons to
be used to operate the garage
door. Do not release the Universal
Home Remote button or the hand-
held transmitter button until the in‐
dicator light changes from a slow
to a rapidly flashing light. You now
may release both buttons. Some
entry gates and garage door
openers may require substitution
of Step 2 with the procedure noted
in "Gate Operator and Canadian
Programming" later in this sec‐
tion.
3. Press and hold for five seconds
the newly-trained Universal Home
Remote button (selected button
from Step 2) while observing the
indicator light and garage door ac‐
tivation.
If the indicator light stays on con‐
tinuously or the garage door starts
to move when the Universal
Home Remote button is pressed
and released, then the program‐
ming is complete. There is no
need to continue programming
Steps 4 through 6.
If the Universal Home Remote in‐
dicator light blinks rapidly for two
seconds, then turns to a constant
light and the garage door does not
move, continue with the program‐
ming Steps 4 through 6. It may be
helpful to have another person to
assist with the remaining Steps
4 through 6.
4. After Steps 1 through 3 have been
completed, locate the "Learn" or
"Smart" button inside the garage
on the garage door opener re‐
ceiver (motor-head unit). The
name and color of the button may
vary by manufacturer.
5. Firmly press and release the
"Learn" or "Smart" button. After
you press this button, you will
have 30 seconds to complete
Step 6.
6. Immediately return to the vehicle.
Firmly press and hold for two sec‐
onds the Universal Home Remote
button, selected in Step 2 to con‐
trol the garage door, and then re‐
lease it. If the garage door does
not move or the lamp on the ga‐
rage door opener receiver (motor-
head unit) does not flash, press
and hold the same button a sec‐
ond time for two seconds, and
then release it. Again, if the door
does not move or the garage door
lamp does not flash, press and
hold the same button a third time
for two seconds, and then re‐
lease.
The Universal Home Remote should
now activate the garage door. To pro‐
gram the remaining two Universal
Home Remote buttons, begin with
Step 1 of "Programming the Universal
Home Remote System".
To Next Page
Loading...
