130 Lighting
Control indicator B illuminates in the
case of a failure 3 107.
High Beam Assist
High beam assist is activated by
pushing the headlamp lever twice.
This feature allows the high beams to
serve as the main driving lights at
night when vehicle speed is faster
than 25 mph and streetlights are not
detected. It switches to low beam
when the camera in the windshield
detects the lights of oncoming or pre‐
ceding vehicles. If there are no re‐
strictions detected, the system
switches back to high beam.
The green control indicator l illumi‐
nates continuously when assist is ac‐
tivated; the blue one 7 illuminates
when the high beams are on.
Control indicator l 3 107.
If flash-to-pass is activated when the
high beams are on, high beam assist
will be deactivated.
If flash-to-pass is activated when the
high beams are off, high beam assist
will stay activated.
To deactivate, push headlamp lever
once.
The most recent high beam assist
setting will be in effect after the igni‐
tion is switched on the next time.
Disabling High Beam Assist under
Fog Conditions
This feature disables the automatic
control of the high beams to avoid
creating glare for oncoming vehicles
when fog is detected. It can last for up
to 10 minutes until the system actually
turns off.
Once it is turned off, switch on high
beam assist manually by pushing the
headlamp lever twice.
Other poor weather conditions, like
rain, can influence the performance of
the system.
Dynamic Automatic Headlight
Leveling
To avoid creating glare for oncoming
traffic, headlight leveling is automati‐
cally adjusted.
Control indicator B illuminates in the
case of a failure 3 107.
Hazard Warning Flashers
Operated with the ¨ button.
Press again to turn the flashers off.
In the event of an accident with airbag
deployment, the hazard warning
flashers are activated automatically.
To Next Page
Loading...
