Sachs Speedforce 50 - Page 41

41
1
3
2
4
5
4
2
NOTES ON MAINTENANCE
Position light
- Remove the rubber cover (4).
- Pull the position light (5) with the bulb
holder by turning carefully to the left out
of the headlight housing.
Installation takes place in reverse order to
disassembly.
NOTE
During installation make sure that the
terminals of the headlight cover (2) and of
the front cover (4) and are fi rmly pushed in
the guides.
Installation takes place in reverse order to
disassembly.
Headlight and position light
Low beam
- Remove the rubber cover (1).
- Disconnect the holder clamp (2).
- Remove the head light bulb (3)
Installation takes place in reverse order to
disassembly.